Topic: TP-Link WR703N Expander - Open Source Hardware

The content of this topic has been archived on 6 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

valentt

25 Jun 2012, 00:21

This project is a small USB Hub & FTDI dual serial/GPIO/JTAG adapter.
It was designed to match the form factor of the TP-LINK WR703N router, but can be used with almost any USB host.

Also there is a nice custom 3d printed case for it... pure awesomeness

http://hackaday.com/2012/06/24/io-exten … fi-router/
http://www.kean.com.au/oshw/WR703N/

(Last edited by valentt on 26 Jun 2012, 07:39)

Post #2

twinclouds

26 Jun 2012, 19:01

Interesting. Not sure how and/or where to get the case.

The discussion might have continued from here.

Page 1 of 1