I was looking to install open-wrt onto a newly purchased Buffalo WBMR-HP-G300H.
I've read the few threads on this forum which mention this router but I have been unable to establish which image file I should use.
The different version seem to boil down to..
openwrt-lantiq-danube-<1>-<2>.image
or
openwrt-lantiq-danube-<2>.rootfs
or
openwrt-lantiq-danube-<1>.uImage
where <1> is one of ...
ARV3527
ARV4510PW
ARV4518PW
ARV4520PW
ARV4525PW
ARV452CPW
ARV7518PW
ARV752DPW
ARV752DPW22
EASY4010
EASY50712
EASY50812
GIGASX76X
NONE
(blank)
and <2> is one of
jffs2-128k
jffs2-256k
jffs2-64k
squashfs
I suspect that <1> represents a hardware version but I'm not sure which one is used by this router. If I look at the hardware page it says it's a Atheros AR922X which isn't listed. Am I to assume then that I should use the "NONE" version or should I use the .rootfs version.
Can anyone shed any light on what these different image files represent and/or more importantly for me, which one I should be using.
Thx
M.
(Last edited by scaryAardvark on 26 Mar 2012, 15:48)