hi?
My router connected to the HUB.The above plug two USB disk. I want them to have a fixed number.
example, port 1 sda, port 2 sdb. More should be done?
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usb 1-1: new high speed USB device number 2 using ar71xx-ehci
hub 1-1:1.0: USB hub found
hub 1-1:1.0: 4 ports detected
usb 1-1.2: new high speed USB device number 3 using ar71xx-ehci
scsi0 : usb-storage 1-1.2:1.0
usb 1-1.3: new high speed USB device number 4 using ar71xx-ehci
scsi1 : usb-storage 1-1.3:1.0
scsi 0:0:0:0: CD-ROM USB DISK CD PMAP PQ: 0 ANSI: 0 CCS
scsi 0:0:0:1: Direct-Access USB DISK CD PMAP PQ: 0 ANSI: 0 CCS
scsi 1:0:0:0: Direct-Access Kingston DT Mini Fun G2 PMAP PQ: 0 ANSI: 0 CCS
sd 1:0:0:0: [sdb] 15124992 512-byte logical blocks: (7.74 GB/7.21 GiB)
sd 1:0:0:0: [sdb] Write Protect is off
sd 1:0:0:0: [sdb] Mode Sense: 23 00 00 00
sd 1:0:0:0: [sdb] Assuming drive cache: write through
sd 1:0:0:0: [sdb] Assuming drive cache: write through
sd 0:0:0:1: [sda] 15187968 512-byte logical blocks: (7.77 GB/7.24 GiB)
sdb: sdb1
sd 0:0:0:1: [sda] Write Protect is off
sd 0:0:0:1: [sda] Mode Sense: 23 00 00 00
sd 0:0:0:1: [sda] Assuming drive cache: write through
sd 1:0:0:0: [sdb] Assuming drive cache: write through
sd 1:0:0:0: [sdb] Attached SCSI removable disk
sd 0:0:0:1: [sda] Assuming drive cache: write through
sda:
sd 0:0:0:1: [sda] Assuming drive cache: write through
sd 0:0:0:1: [sda] Attached SCSI removable disk