Topic: BT homehub v3 type A

Hello all ,  i got this router  (a friend sent me from uk) i look for specs ,  (dual core  cpu ,  preety nice ) and i want to  put open wrt on it , its powerd by lantiq PSB 50810-el V1.2. i found some infos here http://gadgetcat.wordpress.com/category/hardware/router/ ,  beside i got mine , i can help  with  hardware trace,  unmount dismount , reballing etc ( for a noble cause ). what i actualy want with it bside all  good things what comes with open wrt ,  knowing  the LAN port 4 and  the plug  marked as BT infinity  are  both controlled by  gigabit controllers  , i want to use   the bt infinity plug(rj45) as WAN , nas on  its usb port  ,vpn  (the things)
could someone guide me?
thx in advence

Re: BT homehub v3 type A

Hi, this two routers based on lantiq are already supported by OpenWrt:
http://wiki.openwrt.org/toh/arv4518pw
http://wiki.openwrt.org/toh/gigaset/sx76x

but you should connect a serial adapter for interacting the bootloader...

OpenWRT trunk r27772 @ SX763
OpenWRT backfire 10.03 @ DSL-G684T

Re: BT homehub v3 type A

thanks for your reply  i'm  ok with  jtag,uart protocols , i'll search  the home hub3 board for uart pinout , even if board looks  heavily locked down (without  pecific pin aliagment  for  serial pinout or posible jtag ) if i get any of thos can i contact you via pm?
thanks in advence

Re: BT homehub v3 type A

This is the topic where danube is discussed
https://forum.openwrt.org/viewtopic.php?id=15934

OpenWRT trunk r27772 @ SX763
OpenWRT backfire 10.03 @ DSL-G684T

Re: BT homehub v3 type A

thank you