Relocation Factor: I:00000000 - D:00000000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 1
Board Id (0-8) : 96348GW-10
Number of MAC Addresses (1-32) : 11
Base MAC Address : 0c:0a:0a:0a:0a:0a
PSI Size (1-64) KBytes : 24
Flash Block Size (1-128) in KBytes: 0
Auxillary File System Size Percent: 0
udp_send finished
No answer .auto boot ...
*** Press any key to stop auto run (1 seconds) ***
Auto run second count down: 0
Booting from only image (0xbfc10000) ...
Code Address: 0x80010000, Entry Address: 0x80010000
Decompression OK!
Entry at 0x80010000
Closing network.
Starting program at 0x80010000
Linux version 2.6.32.27 (jow@nd-build-02.linux-appliance.net) (gcc version 4.3.3 (GCC) ) #8 Fri Jul 15 05:02:16 CEST 2011
Detected Broadcom 0x6348 CPU revision b0
CPU frequency is 256 MHz
16MB of RAM installed
registering 37 GPIOs
board_bcm963xx: CFE version: 1.0.37-10.3
board_bcm963xx: invalid nvram checksum
bootconsole [early0] enabled
CPU revision is: 00029107 (Broadcom BCM6348)
Kernel panic - not syncing: unable to detect bcm963xx board
With Serial...