The content of this topic has been archived on 6 Jun 2015. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Anybody load OPENWRT on Siemens CL-110 successfully? It runs Linux , Broadcom 6338 chip, 4M flash and 16M ram . I can donate hardware to you if you can port OPENWRT into this Siemens CL-110.
http://wiki.openwrt.org/doku.php?id=oldwiki:openwrtdocs:hardware:siemens:cl110
Source code download link should be: http://opensource.albistechnologies.com … elease.tar
It's same as Dynalink RTA1320 .
I have CL-040, which should be very similar(having a 4-port switch on board). I made it boot ramdisk image via TFTP, it was just a matter of supplying board_info struct with the correct name of the board("RTA1320B_16M" in my case) in the file build_dir/linux-brcm63xx/linux-2.6.39.2/arch/mips/bcm63xx/boards/board_bcm963xx.c. I am not sure if the gpio to led assignment is correct and the reset button is missing altogether. I might find time to fiddle around to find the correct settings. If you have serial cable you might try it too.
The problem is that AFAIK there is no working driver for the DSL modem itself, making openwrt on these wifiless devices somewhat useless.
The discussion might have continued from here.