This connect:
and in putty:
Where is problem?
Thx QWERin
Topic: TL-WR741ND console connect with serial port (NO USB)
The content of this topic has been archived on 22 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
connection settings? 115200, 8N1, no handshake
connection setting is ok
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None*
(*Note: No flow control did not work for my version 1.3, I had to use RTS/CTS)
got some more details of your cable?
Eh, I really hope you not connecting this directly to your PC COM port?
takuto wrote:
Eh, I really hope you not connecting this directly to your PC COM port?
Yes directly :-(
better check the wiki how it is done the right way.
PC COM uses other signal levels than your router port - COM can be as much as 12V, so Im worried bout health of your router serial, which probably uses 3,3 V levels. You should use serial converter, like USB data cable for old phones.
takuto wrote:
PC COM uses other signal levels than your router port - COM can be as much as 12V, so Im worried bout health of your router serial, which probably uses 3,3 V levels. You should use serial converter, like USB data cable for old phones.
The level is one problem, the other problem is the inverted logic
The discussion might have continued from here.
Page 1 of 1