Hi,
I got a new TP-Link TL-WR741ND v2.1. in the wiki http://wiki.openwrt.org/toh/tp-link/tl-wr741nd I read that the version 2.1 is untested. I paid only 17€ so I tested it
I flashed trunk (r27122) for TL-WR741ND v1 through the oem-webinterface (without doing a factory reset). The router didn't reboot, and I wasn't able to access it.
After a poweroff (after 10min) I was able to access failsafe-mode but couldn't mount the jffs2-partiton, so I erased the jffs2-partition and after another reboot everything was working fine (LAN, WAN, WIFI).
So I would like to figure out why I had this issues. Is this "normal", or would resetting the oem-firmware before flashing openwrt have fixed this problem?
I could modify the wiki but first I would like to figure out, if everyone else will face my upgrade-problems.
But as I said TP-Link TL-WR741ND Version 2.1 is working!
(Last edited by eleon216 on 7 Jun 2011, 13:51)