sorry for the cross-post, I think it's better if I create a new thread
I've read these threads
https://forum.openwrt.org/viewtopic.php?id=27793
https://forum.openwrt.org/viewtopic.php?id=19281&p=1
I tried several times to build openwrt for DIR-300 B1, But I always get a brick.
I've done the following steps:
Got v2image from ftp://ftp.dlink.com/GPL/DIR-300_revB/dir300b.v2.02.source.tar.gz (I've extracted only the v2image executable file and put it in /usr/local/bin )
svn co svn://svn.openwrt.org/openwrt/trunk/
cd trunk
./scripts/feeds update -a
./scripts/feeds install -a
make menuconfig
I've set the following:
Target System - Ralink RT288x/RT305x
Subtarget - RT305x based boards
Added the packages autossh (the unique package I really need)
All the rest by default, no changes.
make
cd bin/ramips/
v2image -v -i openwrt-ramips-rt305x-dir-300-b1-squashfs-sysupgrade.bin -o openwrt-dir300b1-squashfs-webflash.bin -d /dev/mtdblock/2 -s wrgn23_dlwbr_dir300b
(as reported on http://wiki.openwrt.org/toh/d-link/dir-300revb )
The image is less then 3Mb
Flashed the new firmware (openwrt-dir300b1-squashfs-webflash.bin) using web Emergency Room.
The flash process seems to proceed without problems.
When the router reboots there no way to connect (I assume that it should get IP 192.168.1.1 on the LAN interface)
No way to connect via http, telnet or ssh, no wireless lan detected
Do anyone can help me to understand where I'm wrong?
Or someone can post the config and/or a working image for DIR-300 B1 ?
(Last edited by Barx on 6 Jan 2011, 16:13)