Dear all,
I flashed WRT160NL with latest backfire image with an ath9k driver.
I set the router as an AP, and one laptop as client. I ran iperf UDP test from AP to the laptop. They are placed pretty close to each other, and the throughput performance is not very good, around 20Mbps.
I did the same experiment with the factory firmware, the UDP throughput is a little higher, around 24Mbps.
Anyone has some experience on ath9k performance at this moment? I came across this ticket
https://dev.openwrt.org/ticket/6165, back then there seemed to be some performance issue with ath9k
thanks a lot in advance!
jt