I still have problems setting up WDS.
The problem in detail is described here.
I can also put it here again, if necessary.
In the meantime i switched the routers, but this also did not help. At the moment, the LinkSys router acts as the "master" AP and the Buffalo is the "client" STA. However, the effect is still the same, exactly as described.
Do i have to configure anything else? Firewall? I read half the Internet, but did not find anything.
All clients (notebooks) connect only to the "master", no way, getting "hand-over" to work. And the "client" STA is not accessible from the clients (notebooks), except ping. LuCi doesn't load, ssh doesn't work. So what's wrong?
As ping works fine, i think, the general setup should be ok.
Any ideas?
Thanks in advance.