OpenWrt Forum Archive

Topic: [D-Link] DSL-G684T powered by OpenWRT

The content of this topic has been archived on 26 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

I have succeeded to flash the DSL-G684T (HW/rev A1) with OpenWRT...

Now need to get familiar with OpenWRT, dd-wrt has spoiled me!

I have followed this steps from wiki.
Now the wiki should be updated...

Before I flash it with alternative firmware, the stock firmware gave this info about it`s enviroment:

# cat /proc/ticfg/env
memsize 0x01000000
flashsize       0x00400000
modetty0        38400,n,8,1,hw
modetty1        38400,n,8,1,hw
bootserport     tty0
cpufrequency    150000000
sysfrequency    125000000
bootloaderVersion       0.22.02
Adam2_Release   0.22.02_b04_Mar 10 2005
ProductID       AR7RD
HWRevision      Unknown
SerialNumber    00:17:9A:D8:A5:71
my_ipaddress    5.8.8.8
prompt  Adam2_AR7RD
firstfreeaddress        0x9401d888
req_fullrate_freq       125000000
maca    00:17:9A:D8:A5:71
mtd0    0x900a1000,0x903f0000
mtd1    0x90010090,0x900a1000
mtd2    0x90000000,0x90010000
mtd3    0x903f0000,0x90400000
mtd4    0x90010000,0x903f0000
autoload        1
autoload_timeout        7
StaticBuffer    120
SW_FEATURES     0X8000
vcc_encaps0     0.0
vcc_encaps1     0.0
vcc_encaps2     0.0
vcc_encaps3     0.0
vcc_encaps4     0.0
vcc_encaps5     0.0
vcc_encaps6     0.0
vcc_encaps7     0.0
modulation      0xffff
eoc_vendor_id   0x444C696E6B000000
eoc_vendor_serialnum    00:17:9A:D8:A5:71_00000000000000
eoc_vendor_revision     20070413
HWA_0   00:17:9A:D8:A5:71
mac_ap  00:17:9A:D8:A5:72
usb_vid 0x0
usb_pid 0x0
usb_man N/A
usb_prod        N/A
invntry_vernum  2007041300000000
#


Cheers!

(Last edited by vpritiskovic on 6 Oct 2010, 20:26)

Have 10.03 installed and have problems with wireless acx driver (Texas Instruments):
first the present diver has only WEP and no WPA encryption,
second, the wireless led does not light when WLAN properly set (router as AP + 1 wireless client connected-my laptop).

How and where to enable leds, gpio???
When wil be WPA supported with TI chip?

So far so good!
Big tnx to community and dev's!!

Have set internal dsl modem and it works without problems as my primary gateway to Internet, its a shame this device has only 4MB flash...
Only minus for this device is poor wireles driver/chip (acx/TI) for instance it has no wpa functionality.

My question is how can I set the Wlan led to light when it is up/active?
Have seen im luci web page possibility to set it but I don't uderstand it, plase help!!!

Hey vpritiskovic,

I also managed to install backfire 10.03 on DSL-G684T but not sure how to configure it so that it acts as a wireless booster/access point for my Comtrend VR-3026e.Can you please share your experience.

Thanks

The discussion might have continued from here.