Topic: Wireless is disabled or not associated

I'm trying to add a USB wireless adapter to the router. The chipset is mt7601u. I just installed 'mt7601u-firmware' and 'kmod-mt7601u' .The USB has worked correctly. I am able to scan nearby network using this USB adapter in Luci. But the Luci warns 'Wireless is disabled or not associated' . I am sure that the 'disabled' value is set 0.
Here is the dmesg info:

usb 1-1.2: reset high-speed USB device number 4 using dwc_otg
[    5.933744] mt7601u 1-1.2:1.0: ASIC revision: 76010001 MAC revision: 76010500
[    5.950867] mt7601u 1-1.2:1.0: Firmware Version: 0.1.00 Build: 7640 Build time: 201302052146____
[    6.417718] mt7601u 1-1.2:1.0: Warning: unsupported EEPROM version 0d
[    6.426757] mt7601u 1-1.2:1.0: EEPROM ver:0d fae:00
[    6.667258] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[    6.668732] usbcore: registered new interface driver mt7601u

the network configuration:

config interface 'loopback'
        option ifname 'lo'
        option proto 'static'
        option ipaddr '127.0.0.1'
        option netmask '255.0.0.0'

config globals 'globals'
        option ula_prefix 'fd11:8629:b448::/48'

config interface 'lan'
        option type 'bridge'
        option proto 'static'
        option ipaddr '192.168.2.1'
        option netmask '255.255.255.0'
        option ip6assign '60'
        option ifname 'eth0'

#config interface 'wan'
#       option proto 'dhcp'
#       option ifname 'eth0'

the wireless configuration

wifi-device 'radio0'
        option type 'mac80211'
        option channel '11'
        option hwmode '11g'
        option path 'platform/soc/3f300000.mmc/mmc_host/mmc1/mmc1:0001/mmc1:0001
        option htmode 'HT20'
    option disabled '1'

config wifi-iface 'default_radio0'
        option device 'radio0'
        option network 'lan'
        option mode 'ap'
        option ssid 'LEDE'
        option encryption 'none'

config wifi-device 'radio1'
        option type 'mac80211'
        option channel '11'
        option hwmode '11g'
        option path 'platform/soc/3f980000.usb/usb1/1-1/1-1.2/1-1.2:1.0'
        option htmode 'HT20'

config wifi-iface 'default_radio1'
        option device 'radio1'
        option network 'lan'
        option mode 'ap'
        option encryption 'none'
        option ssid 'USBadapter'

thanks

Re: Wireless is disabled or not associated

Do you have any clients connected to the station? Sometimes LuCI shows a station as disabled or not associated if there's nobody connected.

Re: Wireless is disabled or not associated

Antek wrote:

Do you have any clients connected to the station? Sometimes LuCI shows a station as disabled or not associated if there's nobody connected.

I have solved this problem by coincidence. Usb port that the usb adapter connects to can not supply enough power. I just changed it to 16db, then it worked.   
Appreciate your answer anyway.