Hello All,
I am using qualcomm SoC and come to across below switch config in uci-default directory network script:
etc/uci-defaults/network
ap161)
ucidef_set_interfaces_lan_wan "eth1 eth2" "eth0"
ucidef_add_switch "switch0" "1" "1" "1"
ucidef_add_switch_vlan "switch0" "1" "6 4"
ucidef_add_switch_vlan "switch0" "2" "0 1 2 3"
It is bit tough to get this configuration as I have experience with others SoC.
How eth1 eth2 LAN interfaces can use port id and tagging?
I was expecting, separate pid for eth1 eth2
like this for eth1 : "1" " 0t 1 2"
eth2: "2" "0t 3 4"
or something like.
Anyone has better explanation on this?
Update: This board use QCA8337 Switch with port 0 as CPU port with total 7 ports and 5 PHY
(Last edited by geek007 on 31 May 2017, 11:20)