Imagine if you have to work with firmware an usually have to change flash chip of your router
you have to de-solder write the chip then soder it to board again, this process takes time
https://www.youtube.com/watch?v=fS4Pdnn_6v0
Topic: TP-LINK TL-WR841N V11 hacked to run flash chip outside
The content of this topic has been archived on 24 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1