Hi everyone,

I've got that router, but with the blue port on the oposite side as normal WR841nd v8

normally we have the following colour for the port (Y= Yellow | B=Blue)

  Y         Y       Y       Y       B
LAN1 LAN2 LAN3 LAN4 WAN

but I have

  B       Y        Y        Y       Y

so I wanted to know where can I change the source to programaticaly change the port ID, so that

LAN1 is WAN (eth0)
LAN2 is LAN1 (eth1)
LAN3 is LAN2 (eth1)
LAN4 is LAN3 (eth1)
WAN is LAN4 (eth1)

I've already searched on the forum, but didn't found anything related
thanks in advanced for the help.