Hello,

I have a Board where is only the MT7620n, a RAM and a Flash. No RJ45 Jacks or USB or anything else.

Shouldn`t I be ably to flash any firmware existing for the Mt7620n on it? Because there is no other peripheral?

I cannot get any firmware running. I really would like to run wrtnode because I need as much GPIOs as Possible.

I tried flashing via tftp but it goes only to a certain line while loading the kernel and restarts. Do I have to take care about UBoot configs? Set any partitions? When uploading via tftp I don`t set the address where the Image has to be written. UBoot does it all by itself.

I sthere a general path I have to follow when flashing openwrt?

Thanks