OpenWrt Forum Archive

Topic: OpenWRT stops halfway through booting

The content of this topic has been archived on 29 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

loaded openwrt-ar71xx-generic-wndr3800-squashfs-factory.img on a WNDR3800 using TFTP, left the PuTTY session  window open to check progress when loading. saw that it stops halfway through.

http://192.168.1.1 won't load either.

what should I do?

I have the TFTP session log if you want to see that. it says stuff about board not calibrated, checksum errors, can't create several files because  directory does not exist, etc.

I'm sorry, but that link was utterly useless.

(Last edited by Cuervo-1800 on 23 Jul 2016, 01:14)

you guys are fucking lame. going back to stock firmware

The discussion might have continued from here.