i need to debrick my nexx router so i got a ch341 programmer and soic8 clamp
but when i connect everything, the router tries to power on due to vcc provided
can i still somehow get around desoldering the chip? i dont have the equipment
(oh and i ripped of the serial console solder points + traces with my solder skills)
Topic: Nexx WT3020 in-system-flashing
The content of this topic has been archived on 6 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
try to press and hold reset button
try to lift up and isolate the pin 8 (vcc) of the spi flash from the pcb using the iron and the tweezers tip
(Last edited by Abdullbasit on 15 Jul 2016, 10:48)
stas2z wrote:
try to press and hold reset button
did not help
Abdullbasit wrote:
try to lift up and isolate the pin 8 (vcc) of the spi flash from the pcb using the iron and the tweezers tip
this worked!
now need to find time resolder it again...
The discussion might have continued from here.
Page 1 of 1