The content of this topic has been archived on 1 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hello people, i'm new in this forum but i use openwrt a lot of time.
I have purchased a tp-link WR841N v10 router but unfortunately it's made in china.
I have read here https://wiki.openwrt.org/toh/tp-link/tl … v9_v10_v11 " 1 MiB flash is not enough to run OpenWrt, needs hardware mod".
There is a way to install openwrt on this router? What is the mod to do?
Thank u so much.
Install more Flash is the only way.
It might be easier to just buy a new router for $14.95 which has more Flash, than to go through the hassle of exchanging the Flash chip.
Thank you tmo26!
Do you know if there are tutorials or howto? I've only tutorials on how to debrick or debug with serial
The discussion might have continued from here.