OpenWrt Forum Archive

Topic: LSD mod for WRT54G

The content of this topic has been archived on 3 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Has somebody any info about this mod? I have found HowTo in german conserning the hardware part of this mod, and also found the framebuffer for Nokia 3310 LCD. The question is how to use this driver, should i compile it like mmc.c in SD card mod. Maybe somebody has already compiled version?

you may have to adjust GPIO numbers of you're using a v4, and/or different wiring.

I've finally got my lcd and wired it up as shown on nanl.de. I was using this firmware from bachpro's site. When i swich on the router nothing appears on the screen, but if i start fb-test it says "The framebuffer device was opened successfully." but only parallel lines appear on the lcd. What should fb-test display on the screen and how i must use it?

Hello all.

Does anyone stil have the schematics from nanl.de ? The post does not exist anymore, and the owner does not have them.
I would appreciate any help.

Thanks in advance!

The discussion might have continued from here.