i really miss up on configuration of my connection LAN,
i was trying to config the router using the open wrt to use with vlan10 of my internet service
install works perfect buy set on my LAN to get dynamic ip (i know its stupid)
so now i can't access my router
anyone know how to fix that ? or the only way is doing TFTP Firmware Flash ???

thanks in advance

create a dhcp server.. with another router.. or TTL adapter... check your device wiki

Thanks by answer,
so if a try create dhcp server how I can found my router settings ?
thanks in advance
ps: I really read wiki and thinking to buy a TTL adapter on ebay

you could restrict the range of ips the dhcp server assigns to 2...
or you could see it on dhcp router assigned leases
or http://www.cyberciti.biz/faq/mapping-la … g-command/

Did you try the backup firmware recovery procedure found here >> http://wiki.openwrt.org/toh/linksys/wrt1900ac

i try but doesn't works =[

guys i did, my router back to live, i has doing wrong reset !! waiting to much before power off again

so i really appreciate all help! thanks a lot !!!!

Good deal. Yeah, timing has to be just right for it to work.