OpenWrt Forum Archive

Topic: Can't unbrick TP-link MR-3220 v2

The content of this topic has been archived on 21 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hey folks!

This old and cheap modem was bricked while trying to flash the factory firmware and now all lights are blinking. I thought it is a good opportunity to gain some experience with unbricking by serial connections, even I don't need this modem anymore.

So, I read a lot on this forum about this specific device and ended up flashing the device successfully with both OpenWrt "factory" and "sysupgrade" firmwares and also the stock firmware on the TP-link site.

But: the problem is still there! All lights blink after restart of the modem.

Setup:

- Ubuntu 14.04 32-bit
- PuTTy
- tftpgui

Any advice plz?

Start your router and take a look at serial console using u-boot
http://wiki.openwrt.org/toh/tp-link/tl-ap121

If your router crash or something else you will see there.


best regards.
gamba47

The discussion might have continued from here.