Hi there,
I've got a small openwrt router here, which seems to have hardware SPI.
The pins a called:
SPI_MISO
SPI_MISI
SPI_CLK
SPI_CS1
When i connect a cable to MISI (not called MOSI, perhaps a mistake?), the device still boots without a problem ( can see it via USB -> serial interface).
If i connect the cable to a MCP3008 or touch the stripped end of the cable, the device does not start anymore.
It takes 1-3s for it to be able to reboot after releasing the cable again.
As I am quite new to this, i have don't have an idea what mistakes I am doing here
Hopefully someone can help me here!
Z oc om