OpenWrt Forum Archive

Topic: tp link 701 nd v2.2

The content of this topic has been archived on 9 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

i have a tp link wireless access point
tp link 701 nd ver 2.2
Firmware Version:     3.17.0 Build 140324 Rel.36563n
Hardware Version:     WA701ND v2 00000000
i want to debrick it so i searched the openwrt wiki and found this topic
http://wiki.openwrt.org/toh/tp-link/tl-wa701nd

PunBB

but the proplem is that the shown pic is not the same as the board of my access point
so how to find the right place for the pins in my access point
this is a pic of my access point

PunBB

From bottom right corner move about 4-5 cm to the top left corner, those 4 holes inside these two white boxes are the serial pins. Pinout is most likely the same as the one mentioned in the wiki (people at TP-Link certainly don't want to search and use a different adapter for each different board).

Thanks a lot smile

The discussion might have continued from here.