OpenWrt Forum Archive

Topic: Where is JTAG pinout?

The content of this topic has been archived on 22 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
vfelhasznalov
26 May 2015, 22:17

Dear users,

I have an Asus router without Bootloader (RedBoot) because I accidentally deleted.
In vain I connect to the serial port of the Bootloader does not start and not work.

I would like to be updated via JTAG programmer but I cannot find output.
How can I create JTAG output? You may be soldered to the output?

Router:
Asus RT-G32 Rv. A

Thanks reply.

(Last edited by vfelhasznalov on 26 May 2015, 22:18)

The discussion might have continued from here.