OpenWrt Forum Archive

Topic: How to install OpenWrt on Aria G25

The content of this topic has been archived on 25 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hi every body,
I'm new to OpenWrt
I want to have an open source for router system, I want to create a router based on Linux and works on ACME Module-Aria G25.
Could you please guide me to the best version of OpenWrt that fits my Hardware !

Thanks for your time.
Firas

Please do not spam in the forums.

ACME Aria G25 according to their site have ATMEL AT91SAM9G25.

This processor class is supported in OpenWrt - see at91 architecture.
Check the wiki pages for this architecture or look with this information in google
to find how to get support for your router model.

https://downloads.openwrt.org/snapshots … 1/generic/
http://wiki.openwrt.org/toh/at91/start

Maybe your device is similar to other devices from the same company: http://wiki.openwrt.org/toh/at91/netusg20

I cannot help you further sorry

zloop wrote:

Please do not spam in the forums.

ACME Aria G25 according to their site have ATMEL AT91SAM9G25.

This processor class is supported in OpenWrt - see at91 architecture.
Check the wiki pages for this architecture or look with this information in google
to find how to get support for your router model.

https://downloads.openwrt.org/snapshots … 1/generic/
http://wiki.openwrt.org/toh/at91/start

Maybe your device is similar to other devices from the same company: http://wiki.openwrt.org/toh/at91/netusg20

I cannot help you further sorry

Really, it wasn't a spam try. I just don't know where to find a response of my question ..
Excuse me ..
Thanks very much for your help, I'll check the mentioned information ..

Thanks for your time. .

(Last edited by firas.om on 31 Mar 2015, 11:37)

The discussion might have continued from here.