Hi,
for my WNDR3800 I build a new image myself and load it via Luci sysupgrade onto the router.
Now I get the following messages in System log and Kernal log:
[ 2.890000] 4 cmdlinepart partitions found on MTD device spi0.0
[ 2.890000] Creating 4 MTD partitions on "spi0.0":
[ 2.900000] 0x000000000000-0x000000050000 : "u-boot"
[ 2.900000] 0x000000050000-0x000000070000 : "u-boot-env"
[ 2.910000] 0x000000070000-0x000000ff0000 : "firmware"
[ 2.920000] 2 netgear-fw partitions found on MTD device firmware
[ 2.920000] 0x000000070000-0x00000016e440 : "kernel"
[ 2.930000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 2.940000] 0x00000016e440-0x000000ff0000 : "rootfs"
[ 2.950000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 2.960000] mtd: device 4 (rootfs) set to be root filesystem
[ 2.970000] 1 squashfs-split partitions found on MTD device rootfs
[ 2.970000] 0x000000640000-0x000000ff0000 : "rootfs_data"
[ 2.980000] 0x000000ff0000-0x000001000000 : "art"
What did I wrong ?
I also load the openwrt factory image via tftp. Same result.
Thanks for your support
Christian