OpenWrt Forum Archive

Topic: Hame F1

The content of this topic has been archived on 7 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
artyru
12 Jan 2014, 12:29

Hi! I want to use openwrt on Hame F1. This is a fast and cheap router with power bank.

Post #2
MasterRoute
18 May 2014, 14:09

I have it too, the SoC is Ralink RT3052, 32 MB, 8 MB flash
I can give telnet access but can't really crack it open, it's very sturdy.

# cat /proc/cpuinfo 
system type             : Ralink SoC
processor               : 0
cpu model               : MIPS 24K V4.12
BogoMIPS                : 239.61
wait instruction        : yes
microsecond timers      : yes
tlb_entries             : 32
extra interrupt vector  : yes
hardware watchpoint     : yes
ASEs implemented        : mips16 dsp
VCED exceptions         : not available
VCEI exceptions         : not available

# free -m
BusyBox v1.12.1 (2012-12-14 06:52:31 EST) multi-call binary

Usage: free 

# free
              total         used         free       shared      buffers
  Mem:        28660        13156        15504            0         1508
 Swap:            0            0            0
Total:        28660        13156        15504
# cat /proc/meminfo 
MemTotal:        28660 kB
MemFree:         15500 kB
Buffers:          1508 kB
Cached:           4348 kB
SwapCached:          0 kB
Active:           4056 kB
Inactive:         3252 kB
SwapTotal:           0 kB
SwapFree:            0 kB
Dirty:               0 kB
Writeback:           0 kB
AnonPages:        1484 kB
Mapped:           1364 kB
Slab:             4440 kB
SReclaimable:      664 kB
SUnreclaim:       3776 kB
PageTables:        232 kB
NFS_Unstable:        0 kB
Bounce:              0 kB
CommitLimit:     14328 kB
Committed_AS:     3596 kB
VmallocTotal:  1048404 kB
VmallocUsed:      1020 kB
VmallocChunk:  1047340 kB


# cat /proc/mtd 
dev:    size   erasesize  name
mtd0: 00800000 00010000 "ALL"
mtd1: 00030000 00010000 "Bootloader"
mtd2: 00010000 00010000 "Config"
mtd3: 00010000 00010000 "Factory"
mtd4: 001335c0 00010000 "Kernel"
mtd5: 0067ca40 00010000 "RootFS"
mtd6: 007b0000 00010000 "Kernel_RootFS"

(Last edited by MasterRoute on 18 May 2014, 14:38)

Post #3
mexus
19 May 2014, 18:52

This category is for un(wanted) hardware (selling, and gifts).
F1 SHOULD have the same hardware as Hame A1.
Hame A1 has been added to the trunk version and you can compile it from source.

Post #4
King0fK0ng
27 May 2014, 06:53

Can someone move this thread to General Discussion?

The HAME F1 is more like the HAME A2 with 8MB FLASH and 32MB RAM.

Post #5
MasterRoute
30 May 2014, 13:20

Yes, please move it to General.

I flashed A2's firmware but now it looks bricked. No WLAN visible, I have yet to connect it to ethernet to check if it grabs IP address.

The discussion might have continued from here.