U-Boot 1.1.4 (Apr 28 2011 - 15:55:09)

AP83 (ar9100) U-boot 0.0.11
DRAM:
sri
32 MB
id read 0x100000ff
flash size 8MB, sector count = 128
Flash:  8 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ag7100_enet_initialize...
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...

Linux version 2.6.32.27 (shown@ubuntu) (gcc version 4.3.3 (GCC) ) #1 Tue May 21 16:34:34 CST 2013
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR9132 rev 2, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
 memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=TL-WR1043ND
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29340k/32768k available (2076k kernel code, 3428k reserved, 414k data, 152k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is TP-LINK TL-WR1043ND
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
yaffs May 21 2013 16:32:28 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: s25sl064a (8192 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x7e0000
Searching for RedBoot partition table in spi0.0 at offset 0x7f0000
No RedBoot partition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 5 MTD partitions on "spi0.0":
0x000000000000-0x000000020000 : "u-boot"
0x000000020000-0x000000160000 : "kernel"
0x000000160000-0x0000007f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=3F0000, len=400000
0x0000003f0000-0x0000007f0000 : "rootfs_data"
0x0000007f0000-0x000000800000 : "art"
0x000000020000-0x0000007f0000 : "firmware"
Realtek RTL8366RB ethernet switch driver version 0.2.3
rtl8366rb rtl8366rb: using GPIO pins 18 (SDA) and 19 (SCK)
rtl8366rb rtl8366rb: RTL5937 ver. 3 chip found
rtl8366rb: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
SQUASHFS error: squashfs_read_data failed to read block 0x28d032
SQUASHFS error: Unable to read metadata cache entry [28d032]
SQUASHFS error: Unable to read inode 0x14cf0962
------------[ cut here ]------------
WARNING: at fs/inode.c:712 0x800ec9dc()
Modules linked in:
Call Trace:[<80069348>] 0x80069348
[<80069348>] 0x80069348
[<8007e0b0>] 0x8007e0b0
[<800ec9dc>] 0x800ec9dc
[<800ec9dc>] 0x800ec9dc
[<80129458>] 0x80129458
[<800eece8>] 0x800eece8
[<80128a64>] 0x80128a64
[<80178d38>] 0x80178d38
[<800db3ec>] 0x800db3ec
[<8011feac>] 0x8011feac
[<801059e0>] 0x801059e0
[<800db9a8>] 0x800db9a8
[<800da668>] 0x800da668
[<800f1a90>] 0x800f1a90
[<80128444>] 0x80128444
[<80128514>] 0x80128514
[<800da70c>] 0x800da70c
[<800da808>] 0x800da808
[<800f2de8>] 0x800f2de8
[<800f2f00>] 0x800f2f00
[<800e4abc>] 0x800e4abc
[<802cfcc4>] 0x802cfcc4
[<801a8e64>] 0x801a8e64
[<802d00c4>] 0x802d00c4
[<800abf70>] 0x800abf70
[<802cf388>] 0x802cf388
[<8006da10>] 0x8006da10
[<802cf26c>] 0x802cf26c
[<8006da00>] 0x8006da00

---[ end trace af2f9c412e05b586 ]---
VFS: Cannot open root device "<NULL>" or unknown-block(31,2)
Please append a correct "root=" boot option; here are the available partitions:
1f00             128 mtdblock0 (driver?)
1f01            1280 mtdblock1 (driver?)
1f02            6720 mtdblock2 (driver?)
1f03            4096 mtdblock3 (driver?)
1f04              64 mtdblock4 (driver?)
1f05            8000 mtdblock5 (driver?)
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)