hello, i just installed openwrt on this device, and i want to know if is possible to make one lan port act as wan, and others 3 to remain switch.
i make settings on , wan and lan side but only i get is all switch turn to wan, and only wireless part get ip and goes to internet.
any advice please.
sorry for bad english.
Topic: Pirelli AGPF change Lan1 ---> Wan
The content of this topic has been archived on 9 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
that should be configurable using swconfig.
tryed to make a config, after that indications, but after save&apply i loose connection to router for good.
needed to reflash.
as uguys know, i not have wan port, because router is adsl-wan based.
maybe someone can put me a configuration here of swconfig.
Thanks.
you should still be able to connect via wifi when you accidentally misconfigure the switch. Or by serial.
ok, i see that after reflash, i have control from serial, but no succes with separate lan1 from others 2,3,4 and make him work as wan.
The discussion might have continued from here.