I installed this firmware to my device (941ND ver 5.0). I found the problem:
- Failsafe not working: Lan interface not working (light's lan or wan not turn on), so I can not connect to device via Ethernet port (lan or wan).Do anyone else have same problem ?
Unfortunately, yes. I successfully bricked my 5.0 version router using that firmware. U-Boot starts the kernel, but it crashes with kernel panic. See last couple of lines in attached log. I've got a serial cable, but was yet unable to interrupt the boot loop.
Regards
Ektus.
U-Boot 1.1.4 (Jun 8 2013 - 15:28:02)
U-boot AP123
DRAM: 32 MB
Flash Manuf Id 0x1c, DeviceId0 0x30, DeviceId1 0x16
flash size 4MB, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag934x_enet_initialize...
No valid address in Flash. Using fixed address
No valid address in Flash. Using fixed address
wasp reset mask:c03300
WASP ----> S27 PHY
file: ag934x.c,line: 189==: set LAN&WAN SWAP. --debug by HouXB
GMAC: cfg1 0x80000000 cfg2 0x7114
eth0: ba:be:fa:ce:08:41
s27 reg init
athrs27_phy_setup ATHR_PHY_CONTROL 4 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4 :0x10
eth0 up
WASP ----> S27 PHY
file: ag934x.c,line: 189==: set LAN&WAN SWAP. --debug by HouXB
GMAC: cfg1 0xf cfg2 0x7214
eth1: ba:be:fa:ce:08:41
s27 reg init lan
ATHRS27: resetting s27
ATHRS27: s27 reset done
athrs27_phy_setup ATHR_PHY_CONTROL 0 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 0 :0x10
athrs27_phy_setup ATHR_PHY_CONTROL 1 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1 :0x10
athrs27_phy_setup ATHR_PHY_CONTROL 2 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2 :0x10
athrs27_phy_setup ATHR_PHY_CONTROL 3 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3 :0x10
eth1 up
eth0, eth1
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OK
Starting kernel ...
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 0001974c (MIPS 74Kc)
[ 0.000000] cpu srif ddr srif cpu 535 ddr 400 ahb 200
AR9341
detect mem size
Uart Init
Booting WASP !!! -:) ...
[ 0.000000] sys id = 121 Atheros AR9341 rev 1.1 (0x0121)
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x01ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x01ffffff]
[ 0.000000] Primary instruction cache 64kB, 4-way, VIPT, I-cache aliases, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Linux version 3.9.4 (root@dd-wrt) (gcc version 4.8.1 (OpenWrt/Linaro GCC 4.8-2013.04 r36550) ) #328 Mon May 27 08:33:25 CEST 2013
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
[ 0.000000] Kernel command line: console=ttyS0,115200 root=1f02 rootfstype=squashfs noinitrd init=/sbin/init
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] __ex_table already sorted, skipping sort
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 29004k/32768k available (2190k kernel code, 3764k reserved, 419k data, 204k init, 0k highmem)
[ 0.000000] NR_IRQS:80
[ 0.000000] Calibrating delay loop... 266.64 BogoMIPS (lpj=1333248)
[ 0.080000] pid_max: default: 32768 minimum: 301
[ 0.080000] Mount-cache hash table entries: 512
[ 0.090000] NET: Registered protocol family 16
[ 0.490000] 25MHZ ref freq
[ 0.510000] bio: create slab <bio-0> at 0
[ 0.520000] Switching to clocksource MIPS
[ 0.520000] NET: Registered protocol family 2
[ 0.530000] TCP established hash table entries: 512 (order: 0, 4096 bytes)
[ 0.530000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)
[ 0.540000] TCP: Hash tables configured (established 512 bind 512)
[ 0.540000] TCP: reno registered
[ 0.540000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.550000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.560000] NET: Registered protocol family 1
[ 0.560000] gpio_proc: module loaded and /proc/gpio/ created
[ 0.570000] wl0gpio_proc: module loaded and /proc/wl0gpio/ created
[ 0.580000] squashfs: version 3.0 (2006/03/15) Phillip Lougher
[ 0.580000] msgmni has been set to 56
[ 0.590000] io scheduler noop registered (default)
[ 0.590000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.620000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
[ 0.620000] console [ttyS0] enabled, bootconsole disabled
[ 0.620000] console [ttyS0] enabled, bootconsole disabled
[ 0.640000] guessed flashsize = 4M
[ 0.640000] scanning for root partition
[ 0.640000] tplink uboot detected
[ 0.650000] guessed bootloader size = 20000
[ 0.660000]
[ 0.660000] found squashfs at 110000
[ 0.660000] Creating 8 MTD partitions on "ar7240-nor0":
[ 0.670000] 0x000000000000-0x000000020000 : "RedBoot"
[ 0.670000] 0x000000020000-0x0000003e0000 : "linux"
[ 0.680000] 0x000000110000-0x0000003d0000 : "rootfs"
[ 0.690000] mtd: partition "rootfs" set to be root filesystem
[ 0.690000] 0x0000003d0000-0x0000003e0000 : "ddwrt"
[ 0.700000] 0x0000003e0000-0x0000003f0000 : "nvram"
[ 0.700000] 0x0000003f0000-0x000000400000 : "board_config"
[ 0.710000] 0x000000000000-0x000000400000 : "fullflash"
[ 0.720000] 0x000000000000-0x000000020000 : "fullboot"
[ 0.730000] libphy: Fixed MDIO Bus: probed
[ 0.730000] tun: Universal TUN/TAP device driver, 1.6
[ 0.740000] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
[ 0.740000] PPP generic driver version 2.4.2
[ 0.750000] PPP BSD Compression module registered
[ 0.750000] PPP Deflate Compression module registered
[ 0.760000] PPP MPPE Compression module registered
[ 0.760000] NET: Registered protocol family 24
[ 0.780000] u32 classifier
[ 0.790000] Performance counters on
[ 0.790000] input device check on
[ 0.790000] Actions configured
[ 0.800000] Netfilter messages via NETLINK v0.30.
[ 0.800000] nf_conntrack version 0.5.0 (453 buckets, 1812 max)
[ 0.810000] nf_conntrack_rtsp v0.6.21 loading
[ 0.810000] nf_nat_rtsp v0.6.21 loading
[ 0.820000] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 0.820000] TCP: westwood registered
[ 0.830000] TCP: hybla registered
[ 0.830000] TCP: vegas registered
[ 0.830000] NET: Registered protocol family 17
[ 0.840000] Bridge firewalling registered
[ 0.840000] 8021q: 802.1Q VLAN Support v1.8
[ 0.850000] searching for nvram
[ 0.850000] nvram size = 0
[ 0.880000] Broken NVRAM found, recovering it (Magic 55AA030E)
[ 0.890000] Atheros AR71xx hardware watchdog driver version 0.1.0
[ 0.890000] ar71xx-wdt: timeout=15 secs (max=171) ref freq=25000000
[ 0.920000] SQUASHFS error: Unknown inode type 15 in squashfs_iget!
[ 0.920000] List of all partitions:
[ 0.930000] 1f00 128 mtdblock0 (driver?)
[ 0.930000] 1f01 3840 mtdblock1 (driver?)
[ 0.940000] 1f02 2816 mtdblock2 (driver?)
[ 0.940000] 1f03 64 mtdblock3 (driver?)
[ 0.950000] 1f04 64 mtdblock4 (driver?)
[ 0.950000] 1f05 64 mtdblock5 (driver?)
[ 0.960000] 1f06 4096 mtdblock6 (driver?)
[ 0.960000] 1f07 128 mtdblock7 (driver?)
[ 0.970000] No filesystem could mount root, tried: squashfs
[ 0.970000] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)
[ 0.970000] Rebooting in 1 seconds..