Topic: Pendo Buddy Box

The content of this topic has been archived on 26 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

Dan9550

11 Feb 2013, 06:44

Does anyone know anything about this device, and whether or not it can run OpenWRT. I have one lying around and it would be great if i could get OpenWRT running on it so i could use it as a Wireless client.

Post #2

Dan9550

19 Feb 2013, 16:20

Ok so i decided to to a little "digging" into this issue, and so far i've determined that:

CPU: Ralink 3050F
RAM: 32MB
Flash: 4MB

I was also able to get a serial console with the device at 115200 8N1

Below are pictures.

Post #3

Dan9550

19 Feb 2013, 16:37

I just managed to get the bootloader over serial at a rate of 57600.

Jboot B252
JRecovery Version R1.2 2010/08/03 13:48
Flash EON-22F6 0xBF000000-0x400000 x16
................
Starting kernel @80000000...
bB

acbbB"AAo

It also seems i can get the router into a recovery mode

Jboot B252
JRecovery Version R1.2 2010/08/03 13:48
Flash EON-22F6 0xBF000000-0x400000 x16
................
reset key pressed!
IP=192.168.123.254 NA=00:60:64:45:21:1B

(Last edited by Dan9550 on 19 Feb 2013, 16:56)

Post #4

Dan9550

20 Feb 2013, 04:30

SO my question now is, Does anyone know how and if i can flash OpenWRT? It seems the hardware should be supported and i can get s TFTP recovery. Is there some generic build of OpenWRT i can flash?

Post #5

Dan9550

26 Feb 2013, 05:00

bump?

The discussion might have continued from here.

Page 1 of 1