Good evening

I changed the settings from static IP to DHCP.
But now I cant acess the router any more. I turn the power Off an on again and when the SYS LED lights up I pushed the reset button. Now the LED is beating fast.
So I think that is the failsafe mode but how can i reset the settings now?

EDIT: installed telnet on Win 8 and i am in now but which command to reset?

I tried firstboot Hope it works

Worked! Can be closed here

(Last edited by napoisamzocken on 7 Feb 2013, 00:52)

Hey god a new problem.
How to cut the original .bin?
Because it is an "Boot" .bin.

I don't quite understand the question. Could you please give more info?

You need to cut first 131584 bytes to revert back to original firmware, if you are sure you have firmware with uboot. But I'd try to tftpoot from your stripped image first, in case you do it wrong, you will brick the router But it seems to support tftp recovery, so not a big deal I think. See wiki http://wiki.openwrt.org/toh/tp-link/tl-wdr4300

how to cut: http://wiki.openwrt.org/toh/tp-link/tl- … l.firmware

(Last edited by nozombian on 4 Mar 2013, 11:11)