Hi! I am trying to install openwrt but I can't get it working
Any hint?
U-Boot 1.1.3 (Jul 5 2011 - 18:31:32)
Board: Ralink APSoC DRAM: 32 MB
relocate_code Pointer at: 81fac000
config usb otg
flash_protect ON: from 0xBF000000 to 0xBF020667
protect on 0
protect on 1
protect on 2
protect on 3
protect on 4
protect on 5
protect on 6
protect on 7
protect on 8
protect on 9
flash_protect ON: from 0xBF030000 to 0xBF03FFFF
protect on 10
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: ZLMNETF8-3.2
--------------------------------------------
ASIC 3052_MP2 (Port5<->None)
DRAM COMPONENT: 256Mbits
DRAM BUS: 16BIT
Total memory: 32 MBytes
Date:Jul 5 2011 Time:18:31:32
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 384 MHZ ####
SDRAM bus set to 16 bit
SDRAM size =32 Mbytes
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
9: Load Boot Loader code then write to Flash via TFTP.
unenter reset button... 0
3: Default: System Boot system code via Flash.
## Booting image at bf050000 ...
Bad Magic Number,7772676E
The device is: http://www.agrade.com.hk/goods.php?id=5021
Got it from ebay months ago but it didn't worked with my 3g (MD300) so the Chinese gave it for free.
The chip says RT3050F but Uboot says 3052
I tried the following images:
openwrt-ramips-rt305x-3g-6200n-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-all0239-3g-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-hw550-3g-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-mofi3500-3gn-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-wl-330n3g-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-wr512-3gn-4M-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-wr512-3gn-8M-squashfs-sysupgrade.bin
openwrt-ramips-rt305x-vmlinux.bin
None worked, the last one is the only one that says "Bad magic number", the other ones say "wrong image".
Any advice to get this running with openwrt?
Thanks!