Hi,
I follow the openwrt forum for a long time, but this time I need some help.
I've got a D-Link DSL-2640B T1, I've accessed the cfe and tried to flash openwrt-DSL2640B-squashfs-cfe.bin, but I got this error:
> tftp -g -f openwrt-DSL2640B-squashfs-cfe.bin -t i 192.168.25.100
Allocating 4194324 bytes for flash image.
Memory allocated
Got image via tftp, total image size: 2752516
tftp:error:71.719:matchChipId:102:Chip Id error. Image Chip Id = 6348, Board Chip Id = 6338.
tftp:error:71.719:verifyBroadcomFileTag:174:chipid check failed
tftp:error:72.235:cmsImg_validateImage:641:Could not determine image format [2752516 bytes]
Tftp Image failed: Illegal image.
Boot log:
CFE version 1.0.37-102.6 for BCM96338 (32bit,SP,BE)
Build Date: Tue Jul 13 15:10:39 CST 2010 (root@localhost.localdomain)
Copyright (C) 2000-2008 Broadcom Corporation.
Serial flash device: name NX25P32, id 0xef15, size 4096KB
current nvram version is 0
100 MB Full-Duplex (auto-neg)
CPU type 0x29010: 240MHz
Total memory: 16777216 bytes (16MB)
Boot Address 0xbfc00000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 1
Board Id (0-14) : 96333W
Number of MAC Addresses (1-32) : 11
Base MAC Address : 34:08:04:xx:xx:xx
PSI Size (1-64) KBytes : 24
Can anyone help me over here?
Thanks in advance!