OpenWrt Forum Archive

Topic: Buffalo Tech WZR-300HP

The content of this topic has been archived on 26 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
fbrier
30 Nov 2012, 18:28

Buffalo Tech introduced a new router.

http://www.buffalotech.com/about-buffal … ter-lineup

One person posted a message indicating it had the same amount of Flash and RAM as the WZR-HP-G300NH (32MB/64MB), which the above press release says the WZR-300HP is the replacing.  The WZR-HP-G300NH is supported in Backfire.  However, Buffalo technical support did not have the stats on the router and their information conflicted with the press release in which router it was based on.

Does anyone else own this router?  Could you please post its hardware specs?  Does it work with OpenWRT?  Thank you.

Fred

Post #2
fullstop
6 Dec 2012, 03:08

I got one and flashed it with the latest Attitude Adjustment, after getting a working serial cable to verify the results in case of a problem.  It booted fine, and appears to function exactly the same as the previous model.

The DDR2 module is different since their previous part was end of life, which was probably enough to warrant a new board spin.

I have a boot log and whatnot added to the wiki.

The discussion might have continued from here.