Hello all,
Decided to add sdhc card to my trusty dockstar, but cannot get it working. Dockstar runs attitude_adjustment, installed kmod-mmc and kmod-mmc-spi, but no any message in dmesg that I would even have card attached, not even an error.
Used this http://archlinuxarm.org/forum/viewtopic … &t=258 for attaching sd card. Hardware seems to be ok, measured resistors, lines seems not to be connected directly to GND or VCC.
May be someone has it working and can point which modules should be loaded and may be something else to be done?
Thanks in advance!