OpenWrt Forum Archive

Topic: Nexaira BC2 serial console

The content of this topic has been archived on 9 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
oreggin
28 Sep 2012, 15:37

Hi,

anybody knows what is the pinout and signal level voltage of the BC2 serial console?

I found a pdf what tells me the 57600 baudrate and 8N1 bitsettings.

Regards,
oreggin

Post #2
aport
18 Oct 2012, 23:15

I should know this; I used to work there and I wrote that PDF you found tongue

IIRC it's 3.3 VCC and should be GND - TX - RX. Or maybe it was TX - RX - GND. It's been a while, sorry sad

I just used a Nokia CA-42 cable.

(Last edited by aport on 18 Oct 2012, 23:16)

Post #3
arfett
19 Mar 2013, 23:35

Pinout (left to right):
RX | TX | Ground | VDD 3.3V

Settings:
Baud rate 57600
Data bits 8
Parity None
Stop bits 1
No flow control

The discussion might have continued from here.