OpenWrt Forum Archive

Topic: BCM6333 with Board ID 96333W

The content of this topic has been archived on 31 Jan 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

This is the thing, i lost 2 routers in a storm, i placed an old Arnet Pirrelli DRG A125G, this issue with this thing is that it hangs every now and then, and it maybe a firmware issue, so i thinking about flashing it with OpenWRT, but, this one does not have the same hardware that the Pirrelli A125G listed on the wiki...


Device Info
Board ID:    96333W
Software Version:    DCWF_TA_4_1_1
Bootloader (CFE) Version:    1.0.37-13.2 P01
Wireless Driver Version:    4.174.64.19.cpe1.0sd

Thats what stock firmware says.


CPU is a BCM6333KFBG
SPI Flash chip is 25X32VSIG (4mb)
Ram chip is ESMT M12L128168A-6T
Switch chip is Broadcom BCM5325EKQMG
Wifi chip is Broadcom BCM4312KFBG
ADSL chip is Broadcom BCM6301KSG

It also has USB, but i dont thing it can be configured as host.

If i compile Openwrt as default for BCM63xx, there is not a 96333W on the bin folder, How i can compile one for 96333W?

So Weird... the "D-Link DSL-2460B H/W Ver: T1" (very common in Brazil) has *exactly* the same components for CPU, SPI Flash, RAM, Switch, Wifi and ADSL!!!

It is a very good reason for releasing a OpenWRT version for us. Isn't it?

Board ID: 96333W
Software Version: SEA_1.01
Bootloader (CFE) Version: 1.0.37-10.3 for BCM96338 (32bit,SP,BE)

Default host run file name: vmlinux
Default host flash file name: bcm963xx_fs_kernel

The discussion might have continued from here.