OpenWrt Forum Archive

Topic: brcm63xx and Dlink DWL G122 (rt73usb)

The content of this topic has been archived on 13 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hello at all,
I've an AGPF that is a brcm63xx based router with backfire running. It comes with a boradcom wireless interface and I use b43 driver in client mode to share internet connection from wireless to ethernet ports.
Now I would like share internet connection via wireless using an USB wireless adapter (because b43 driver doesn't support virtual interfaces building). My usb wireless adapter is Ralink based and I've installed kmod-rt73-usb with his dependencies via opkg. Driver sesms work fine because dmesg say that driver is registred when I plug in the adapter. The problem is that I can't see the new interface (like wlan1).
What can I do to use the usb wireless adapter interface like AP?
Thanks at all.

Ivan

i have exactly the same problem. This not occurs with my other usb rtl8187.
When i do an "lsusb" i can see this:

Bus 001 Device 002: ID 07d1:3c03 D-Link System AirPlus G DWL-G122 Wireless Adapter(rev.C1) [Ralink RT73]


i had install ALL prequisites , such as kmod- modules for usb and rt73 modules......

i dont know what im doing wrong.

The discussion might have continued from here.