ecc wrote:You just forgot to flash the kernel to NAND. So if you press the reset button you should still get back into u-boot so you can try again. You didn't do any other "nand erase" commands, did you?
I did install
#single stage bootloader
mw 0x800000 0xffff 0x40000
tftpboot 0x800000 openwrt-kirkwood-dockstar-u-boot.bin
nand erase 0x000000 0x80000
nand write.e 0x800000 0x000000 0x40000
setenv bootcmd nand read.e 0x2000000 0x100000 0x400000\; go 0x2000000
saveenv
and the uImage
mw 0x6400000 0xffff 0x300000
tftpboot 0x6400000 openwrt-kirkwood-uImage
nand erase 0x100000 0x400000
nand write.e 0x6400000 0x100000 0x400000
After installing successfully
mw 0x6400000 0xffff 0x200000
tftpboot 0x6400000 openwrt-kirkwood-Dockstar-jffs2-128k.img
I forgot to type these 2 lines:
nand erase 0x500000 0xfb00000
nand write.e 0x6400000 0x500000 0x200000
and booted
reset does not seem to work,no blinking
but the device is hot ...