I tried to separate out the eth4 lan port to a separate "network config" using luci, and created a new Lan group called dmz.
at same time, I then disabled the dhcp on these ports.
Now, when I try to start safemode, or otherwise, these ports seem to be disconnected from any lan interface.
Because of this, I cannot connect to router from safe mode.
Ideas? pointers in a direction?
If I make a serial cable, can I re-flash, or reset to defaults from the serial port? or can I only do this via telnet at this stage?
If I can only do via telnet, how do I get the lan ports back into the lan group.
TIA
Aj