got this router and wanted to start. I found some infos, like:
backing up the data/flash:
http://wiki.openwrt.org/toh/linksys/wag160n#hints
http://wiki.openwrt.org/toh/linksys/wag160nv2

the original webinterface just allows to backup the router.cfg file...

what the bootloader does:
http://wiki.openwrt.org/toh/linksys/wag … bootloader

BUT what I completely miss is HOW to get access to the router at all
-only via sercomm tool? (and by soldering a connector to the j1?)
-or do I have anthor method vis ethernet?

EDIT:
Just another question. I just found this:
http://wiki.openwrt.org/toh/linksys/wag … bootloader
"Ethernet access is fine, but WLAN is currently not working as we miss some PCI configuration for the AR9223"

Has this status changed?
/EDIT

EDIT2:
I was searching around a while in the forum, which makes me mainly more confused...
From what I read, I understand:
flashing is possible (with some tweaks), but the OpenWRT running on the device has NO DSL and wirelessLAN. Did I got that right?
/EDIT2

(Last edited by mclien on 14 Jan 2012, 23:05)