Hey I have a question on this package. First of all, thank you for this great package, keep the good work up.
I'm running it on an TP-Link WR1043ND router with 10.03 RC3.
multiwan package is installed in version 1.0.19-1, version 1.0.17 and 1.0.18 spams the syslog because of my 3g connection.
luci-app-multiwan package is installed in version 1.0.16.
WAN is an K3765-HV USB dongle via 3g ppp flatrate on Vodafone.de net.
WAN2 is an 2,0/0,2 MBit DSL line (which is connected through an separate router) configured as static IP on the WAN port.
The failover does not work for me reliable on the 3g link. After a certain time it declares the connection as dead and disables it. But the modem is still connected (no disconnect in the syslog, the led of the usb dongle is still static on, so hwconnect is there). Also it does not try to do a reconnect. So useless in combination with 3g for me.
I tried different configs.
As 'dns' I tried auto and also the correct dns1/dns2 of my vodafone 3g, which are fixed.
As 'icmp_hosts' I tried www.vodafone.de, and also the dns or wan gateway.
As 'timeout' I tried from 3, 5 to 10 sec.
As 'health_fail_retries' I tried from 3, 5 to 10 tries.
And of course several combinations of that.
The result is always the same, after a certain time multiwan declares the 3g line as dead and disables it. No reconnect or anything else. But the line is up and running fine, I can see no disconnect on the syslog by chat or pppd and as reported the usb dongle also indicates an connect with an static led in blueish or greenish (3g or gprs) when connected.
The 3g is realized by pppd with comgt (and chat), so serial link.
So how to investigate on that issue?
I would appreciate any suggestions.