OpenWrt Forum Archive

Topic: Remote reset or RedBoot access on Ubiquiti Router Station

The content of this topic has been archived on 21 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
BizarroSephiroth
23 Oct 2009, 10:06

Hi!

Are there any pins on RS board to which external reset could be connected. I'd like to avoid soldering to original switch pins.
Even better solution would be some early access to bootloader command prompt using telnet over ethernet (serial console can not be used)  available for several seconds before boot script initialization. Is this possible on RS with standard RedBoot configuration?

thanks

Julian

(Last edited by BizarroSephiroth on 23 Oct 2009, 10:52)

Post #2
mazilo
23 Oct 2009, 13:28

What is RS? On my FON2100 unit, I can use telnet 192.168.1.254 9000 to access its RedBoot prompt.

The discussion might have continued from here.