OpenWrt Forum Archive

Topic: Jtag Pcb

The content of this topic has been archived on 6 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
kaevee
2 Oct 2009, 13:54

Hi,

I had managed to recover routers without resorting to JTAG till now. I managed to brick couple of routers in last few weeks and needed to recover them. As I did not want to solder a buffered JTAG on a breadboard, I got a buffered JTAG pcb done based on schematic on Wiki.

As there was a MoQ for PCB's I have some PCB's to spare. If anyone needs a PCB, please let me know. I will try to mail it as long as Postal charges are viable to your location.

Please note that the schematic is modified with suggested changes on Wiki which can be enabled/disabled with a Jumper.

Thanks,

Venkatesh K

(Last edited by kaevee on 2 Oct 2009, 13:56)

Post #2
mazilo
2 Oct 2009, 14:15

PM sent to you.

Post #3
marca56
2 Oct 2009, 17:29

Kaevee:

PM sent to you as well.

marc.

The discussion might have continued from here.