Topic: kamikaze bin for DLINK 504T

Hi,
i have a DLINK 504T.
I try to search specific information on it on
http://nuwiki.openwrt.org/oldwiki/Hardware/DLink
http://wiki.openwrt.org/oldwiki/openwrtdocs/hardware/d_link/dsl_502t
and on forum
https://forum.openwrt.org/viewtopic.php?id=18166
https://forum.openwrt.org/viewtopic.php?id=5141
about which file i have to do to install kamikaze on 504T.
In http://downloads.openwrt.org/kamikaze/8.09.1/ar7/ there are a lot of files on AR7
but in the previus link i not found any directly reference to 504T.
I think that the 504T hasn't WIFI so i can use generic openwrt-ar7-jffs2-XXk.bin but what kind of "K-type"?
* 128K type ?
* 64K type ?

Thanks in advance!
Bye

Skardee

Re: kamikaze bin for DLINK 504T

A while ago I flashed OpenWRT on my DSL-504T using this procedure http://ziofork.altervista.org/appunti/openwrt_su_d-link_dsl-504t (unfortunately is only in italian, but I believe you can follow the steps). There's linked also the image used by the author. Once you have OpenWRT on the device, I believe you can just use mtd command to update the version.

If you want to use the pre-compiled images, I believe you could use the squashfs version so openwrt-ar7-squashfs.bin but I can't tell you for sure.

Regards.

Re: kamikaze bin for DLINK 504T

Hi gianfranco74,
I'm italian too, so there are no problems with the link that you give me.
I decide to use openwrt because my 504T give me some sw problem, so i'll try to change system, before to change router.
I try and then i'll post my experience.

Thank you!

Best Regards

Skardee