Hello!
I flashed my router with a bad firmware and now doesn't work.

My router is crypto f360 which is the same with the beetel 220bxi.
The leds "power" and "link" lights up and the lan led blink when i have connected router to pc lan port.

I can't ping the router.I have pushed reset button but no luck.

The router is BCM6338KFBG based with SST39VF3201 eeprom chip(4mbytes).
Board ID: 96338L-2M-16M
Software Version ID: V8.11.01.01 
Firmware Version: 3.06L.05.A2pB021g.d19d
Bootloader (CFE) Version: 1.0.37-6.8

inside the router has one 4 pins connector (serial port ?)
I measured +3,3 volts between pins: 1-2 , 3-2 , 4-2
and -3.3 volts between pins: 2-1 , 2-3 , 2-4
between pins: 1-3, 3-4  the voltage is 0 volts.

http://img443.imageshack.us/img443/9501/dsc00094okni4.jpg


how can i recover the router by flashing original firmware back ?

how to make o serial cable ?

from console can i reflash the router ?

any help ?

thanks!

(Last edited by elomask on 19 Feb 2008, 17:37)