Got a Zyxel P334WT router and after checking the PCB, i found out that it seems to be the same board as the P335WT.
Only the USB port is not soldered.
I will try to add a USB plug to the board, but i am not quite sure if there are some other components (resistors,capacitors,..) needed to get it working.
Does anyone have a clear picture of a P335(WT), where i could figure out what else is missing?
Thx in advance for any help
Topic: USB on Zyxel P334WT (ADM5120 board) like P335WT
The content of this topic has been archived on 6 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1